Contents - Toshiba TLP-X10U Owner's Manual

Projection on the screen (continued)
Control panel
Remote control
(Main unit side)
AUTO
3 KEYSTONE
INPUT ON/STANDBY
LASER
AUTO
KEYSTONE SET VOL/ADJ.
L-CLICK R-CLICK
VOLUME/ADJUST
ENTER
MENU
MENU ENTER EXIT
PIP FREEZE
RESIZE
CALL MUTE
TEMP LAMP
BUSY
3
AUTO
SET
Note
The types of input sources selected when the INPUT button is pressed repeatedly can be
set from the menu screen.
(At shipping from factory, the projector is set so that the RGB signal source input to the
COMPUTER IN 1 connector and the video signal source input to the VIDEO jack can be
selected.)
EXIT
INPUT
3
• If you project an image from a computer with an LCD screen while monitoring the image on
ON/STANDBY
the computer, the image may not be projected properly, depending on the computer model.
In this case, turn off the computer display. For details on controlling the computer display, etc.,
ON
refer to the computer's manual and description on the software for the computer used.
FAN
• The projector projects an image by XGA signal (1024 x 768) in full screen.
• The projector projects an image by VGA or SVGA signal in full screen size, the image quality
may be slightly degraded. But, when you set the "Screen size" in the menu screen
"Thru", the display size will be reduced without the image quality be degraded.
• The projector has simplified display compatibility with the signals whose picture dots are more
than that of XGA signal. (However, letters and lines can be inequal or a part can be missing.
Some signals may not be projected at all.)
• It is recommended to set an external monitor connected to the computer to XGA mode (1024
x 768).
• The projector can be also applied to DDC2B (Display Data Channel 2B). If your computer is
applied to the DDC, start up your computer after turning on the projector.
Select the input source.
INPUT
Press the INPUT button repeatedly to select it.
The icon of the input source selected appears.
INPUT
(You can select "Camera" when using the model with a document
imaging camera.)
COMPUTER-1 COMPUTER-2
48
(Signal sent from the computer)

CONTENTS

Video S-video Memory card
Continued
29
Camera
to
54