Turning The Power Off; Contents - Toshiba TLP-X10U Owner's Manual

Turning the power off

Control panel
Remote control
(Main unit side)
AUTO
1,2
KEYSTONE
INPUT ON/STANDBY
LASER
AUTO
KEYSTONE SET VOL/ADJ.
L-CLICK R-CLICK
VOLUME/ADJUST
ENTER
MENU
MENU ENTER EXIT
ON/STANDBY
PIP FREEZE
RESIZE
CALL MUTE
TEMP LAMP
BUSY
1
2
AUTO
SET
EXIT
INPUT
1,2
ON
2
FAN
Indicators
Notes
• The projector consumes about 20W of power in the standby mode. We recommend you to
unplug the power cord when not using the projector for long periods of time.
• Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the
power by unplugging the power cord while the projector is operating or the light source lamp is
being cooled will shorten the lamp's duration life.
Press ON/STANDBY after using the projector.
An instruction message appears.
Press ON/STANDBY again.
Cooling starts. Once cooling is completed, the LAMP and FAN
indicators turn off and the standby mode is set. (The ON
indicator turns in orange.)
LAMP ON
(Green) (Orange)
FAN
Flashing
(Green)
A
To protect the light source lamp, the LAMP indicator blinks as long as
A
a minimum of cooling is necessary. The power cannot be turned back
on during this time. Unplugging the power cord at this time will shorten
the lamp's duration life.
The cooling fan continues to run for a while to expel the heat remaining
B
inside. If you are in a hurry, however, you may unplug the power cord
at this time.
The standby mode is set.
C

CONTENTS

LAMP ON LAMP
(Off) (Orange) (Off)
FAN
(Green)
B C
31
ON
(Orange)
FAN
(Off)