Cleaning; Repair; Kx 165A Disassembly - Honeywell Bendix/King KX 165A Maintenance Manual

BENDIX/KING
O. Wiring/Coaxial Cable
Inspect open and laced wiring of chassis, subassembly chassis and parts of
equipment for breaks in insulation, conductor breaks, cut or broken lacing and
improper dress in relation to adjacent wiring or chassis.
5.3.2

CLEANING

A. Using a clean, lint-free cloth lightly moistened with a regular cleaning deter-
gent, remove the foreign matter from the equipment case and unit front pan-
els. Wipe dry using a clean, dry, lint-free cloth.
B. Using a hand controlled dry air jet (not more than 15psi), blow the dust from
inaccessible areas. Care should be taken to prevent damage by the air blast.
C. Clean the receptacles and plugs with a hand controlled dry air jet (not more
than 25psi), and a clean, lint-free cloth lightly moistened with an approved
cleaning solvent. Wipe dry with a clean, dry, lint-free cloth.
5.3.3

REPAIR

This section describes the procedure along with any special techniques for replacing damaged or
defective components.
A. Connectors
When replacing a connector, refer to the appropriate PC board assembly
drawing and follow notes to insure correct mounting and mating of each con-
nector.
B. Crystal
The use of other than a Honeywell crystal is considered an unauthorized
modification.
C. Wiring/Coaxial Cable
When repairing a wire that has broken from its terminal, remove all old solder
and pieces of wire from the terminal, restrip the wire to the necessary length
and resolder the wire to the terminal. Replace a damaged wire or coax with
one of the same type, size and length.
D. Transmitter Repair
No provision is made for component level troubleshooting on the Transmitter
Board. When such work is necessary the radio should be returned to the fac-
tory.
5.3.4

KX 165A DISASSEMBLY

5.3.4.1 Removal of the Top Cover
A. Remove the two (2) screws (See
B. Remove the two screws on each side (4 total) that secure the top cover side wall
tabs to the base casting.
Rev 0, Jun/2000
Figure 6-2) from the top surface of the unit.
15610M00.RCD
KX 165A
Page 5-41