Panasonic CF-VEB071 Service Manual page 13

4. Removing
PCB
1. Remove the 3 screws and release the EXT bus angle
bracket block.
2. Disconnect the DC IN connector.
Screw
<A>:XYN26+J5FN
3. Remove the 2 screws and release the I/O dock leg.
4. Remove the 4 flexible cables.
Screw
<A>:XYN2+J10FN
5. Removing the DC IN
Connector
1. Remove the single screw <B> at the side.
2. Remove the 2 screws <A> and release the DC IN
connector.
Screw
<A>:XYN26+J5FN
<B>:DFHE5025YA
the DU Connector
< Preparation for Speaker>
1. Soldering the speaker cable as shown below.
8-3