Miele DA 3668 Operating And Installation Instructions page 57

When fitting a 900 mm wide rangehood
into a 900 mm wide housing unit
without side base supports, additional
alignment and securing of the
rangehood is required. This is done
using the two brackets on the back wall
of the unit.
If the wall unit does not have a solid
back panel, the rangehood can be
secured directly to the wall using the
screws and plugs supplied.
An Allen key is supplied in case the
screws are difficult to access.
 Loosen the retaining bracket screws
and push the brackets back against
the rear wall.
 Align the rangehood and mark the
position of the fixing holes in the wall
unit.
 Now secure the brackets to the wall
unit.
 Realign the rangehood and tighten up
the screws on the housing unit.
 Conceal the fixing holes on the
deflector plate which are not used.
Suitable adhesive covers are
supplied.
Installation
57