Miele DA 3466 Operating And Installation Instructions
Hide thumbs
Also See for DA 3466:
- Operating and installation instructions (52 pages) ,
- Operating and installation instructions (48 pages) ,
- Operating and installation instructions (48 pages)
Related Manuals for Miele DA 3466
Summary of Contents for Miele DA 3466
- Page 1 Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU M.-Nr. 10 122 160...
-
Page 2: Table Of Contents
Contents Warning and Safety instructions ................4 Caring for the environment ................. 13 Guide to the appliance..................14 Description of the functions ................16 Operation ......................17 Switching the fan on ....................17 Selecting a power level ..................17 Fan run-on after cooking..................18 Switching the fan off .................... - Page 3 Contents After sales service and warranty ................ 44 Position of the data plate ..................44 Technical data ...................... 45...
-
Page 4: Warning And Safety Instructions
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. Where a recirculation rangehood is fitted above a gas cooktop, please ensure that there is an adequate supply of fresh air into the room in which it is installed. - Page 5 Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
-
Page 6: Technical Safety
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage. - Page 7 Miele replacement parts are used. If the mains connection cable is damaged, it must only be replaced by a Miele authorised service technician in order to avoid a hazard. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
- Page 8 Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the rangehood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
- Page 9 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the rangehood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 10: Correct Use
Warning and Safety instructions Correct use Never use an open flame beneath the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard. -
Page 11: Correct Installation
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. There is a risk of fire if the rangehood is not cleaned as described in these operating instructions. - Page 12 The steam could reach electrical components and cause a short circuit. Accessories Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability.
-
Page 13: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and can normally be recycled. -
Page 14: Guide To The Appliance
Guide to the appliance... - Page 15 Guide to the appliance a Exhaust connection for air extraction/recirculation b Touch controls c Grease filter d Pull-out deflector plate e Cooktop lighting f NoSmell active charcoal filter (special accessory for recirculation mode) g On/Off touch control for the fan h Touch controls to select the fan power setting i On/Off touch control for the cooktop lighting j Drop-down front panel...
-
Page 16: Description Of The Functions
Rangehoods set up for operation with an external motor have to be connected to a Miele external motor located in a suitable position outside the room in which the rangehood is installed. The external motor is linked to the... -
Page 17: Operation
Operation Switching the fan on Automatic switch-off of the Intensive setting Pull the deflector plate out. For optimum extraction with minimum You can set the Intensive setting so that noise levels, always pull the deflector it always only runs for 10 minutes plate out to its full extent. -
Page 18: Fan Run-On After Cooking
Operation Fan run-on after cooking It is advisable to run the fan for a few minutes after cooking has finished to neutralise any lingering vapours and odours in the air. Switching the fan off Push the deflector plate in to switch the fan off. -
Page 19: Energy Saving Tips
Energy saving tips This rangehood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the rangehood cannot operate efficiently and this causes increased operating noise... -
Page 20: Cleaning And Care
To help prevent re-soiling, a Switch the rangehood off before any proprietary conditioning agent for cleaning or maintenance work is stainless steel (Original Miele Care carried out. product for stainless steel) can also All external surfaces and controls can be used. -
Page 21: Grease Filter
Cleaning and care Grease filter The re-usable metal grease filter in the appliance removes solid particles from the kitchen vapours (grease, dust, etc.) preventing soiling of the rangehood. An oversaturated filter is a fire hazard. When removing the grease filter do not tilt it downwards at an angle. - Page 22 Cleaning and care Unsuitable cleaning agents Fitting the grease filter Unsuitable cleaning agents can cause damage to the surface of the filters if used regularly. Do not use: – cleaning agents containing descaling agents, – powder cleaners or cream cleaners, –...
-
Page 23: Nosmell Active Charcoal Filter
Disposing of the charcoal filter Replacement charcoal filters can be The used charcoal filter can be obtained from Miele or via the internet disposed of with the normal at www.miele-shop.com (depending on household waste. country). See back of booklet for contact details, and "Technical data"... -
Page 24: Changing A Lamp
Manufacturer........ EGLO Lamp type ........GU10 Specification ........ 11427 Wattage ........... 3 W These lamps are available from Miele or from specialist retailers. Pull out the deflector plate, and remove the grease filter as described earlier. Switch off the fan and the lighting. -
Page 25: Installation
Installation Before installation Before installation, it is important to read the information given on the following pages as well as the "Warning and Safety instructions" at the beginning of this booklet. -
Page 26: Assembly Parts
Installation Assembly parts... - Page 27 Installation a 1 exhaust connection for exhaust ducting 150 mm. 8 screws 4 x 15 mm b 1 non-return flap for securing the rangehood in the wall for fitting into the exhaust unit. connection on the motor unit (not needed for recirculation mode).
-
Page 28: Appliance Dimensions
Installation Appliance dimensions a Extraction mode: the height of the wall unit and cut-out dimensions must take account of any accessories fitted, e.g. silencer, DSM module. b Recirculation mode with conversion kit DUU 151. c DSM 400 accessory. d When installing the rangehood with a DAR 3000 drop-down frame, make sure that you note the different wall unit height (please refer to the dimensions given in the DAR 3000 building-in diagram). -
Page 29: Safety Distance (S)
Installation Safety distance (S) The minimum distances between the top of a cooktop (excluding trivets, dials - depending on model) and the bottom of the rangehood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance. See also "Warning and Safety instructions". -
Page 30: Installation Recommendations
Installation Installation recommendations – To achieve optimum vapour extraction, the rangehood must cover the cooktop. It should be positioned centrally over the cooktop, not to the side. – The cooktop should be no wider than the rangehood and, if possible, it should be narrower, especially for safety distances greater than 750 –... - Page 31 Installation a Example: Installation without a front panel fitted and with the front edge of the deflector plate flush with the front edge of the furniture housing unit. b Example: Installation with a front panel to match the kitchen furniture. This installation requires dimension b for the front panel plus 5 mm for the DML 400 fixing bracket to be...
- Page 32 Installation Secure the spacer strip underneath the housing unit sides, flush with the rear wall. The brackets are designed for 16 and 19 mm thick unit sides. Orientate the bracket so that the vertical depth matches the thickness of the unit side.
- Page 33 Installation To avoid scratching the deflector plate, do not remove the protective film between the deflector plate and the casing until the rangehood has been placed in the housing unit. Installation of the rangehood is carried out without the grease filter placed in position.
- Page 34 Installation Secure the rangehood to the brackets from below using two Secure the retaining brackets to the screws on each side. rear wall using the screws supplied. The housing must be secured firmly to the rear wall of the furniture unit. If this is not ensured, the housing may lean forwards and the canopy could be damaged when it is pulled...
-
Page 35: Attaching The Front Panel
Installation Attaching the front panel The front of the deflector plate can be fitted with a front panel to match existing kitchen furniture units. The front panel must not exceed 1300 g. This applies to front panels with a depth of up to 30 mm. For larger and heavier front panels, the weight must be reduced, e.g. -
Page 36: Aligning The Deflector Plate
Installation Aligning the deflector plate Fitting the grease filter The position of the deflector plate can be brought forward by up to 35 mm using the adjusting screws on either side of the deflector plate. This allows the deflector plate to be aligned to the front of the kitchen furniture units on either side. -
Page 37: Set Up For Extraction Mode
Installation Set up for extraction mode Place the exhaust ducting on the exhaust connection for the If required, install the non-return flap. rangehood. Check that the flap opens easily and See "Connection for air extraction" closes by itself. Depending on the for further instructions on fitting the model of rangehood, the non-return ducting. -
Page 38: Set Up For Recirculation Mode
The DUU 151 conversion kit, available from Miele, is required for operating the rangehood in recirculation mode. You will also need a charcoal filter (see "Technical data"). -
Page 39: Mains Connection
Installation Mains connection Refer to the notes in “Electrical connection” and “Warning and Safety instructions” before connecting to the electricity supply. For appliances connected to an external motor (...EXT models): Connect the rangehood and the external motor using the control cable and the six-pole plug connector. -
Page 40: Electrical Connection
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. -
Page 41: Connection For Air Extraction
Connection for air extraction – A reduction in diameter will Before installation, it is important compromise the extraction to read the information given on the performance of the rangehood. following pages as well as the "Appliance dimensions" and the –... -
Page 42: Condensate Trap
Connection for air extraction When ducting is horizontal it must be exhaust socket. laid to slope away at at least 1 cm The arrow on the housing indicates per metre. This is to ensure that the direction of airflow. condensate cannot drain back into The condensate trap will be integrated the rangehood. - Page 43 Connection for air extraction Recirculation mode The silencer needs to be positioned between the exhaust connection and the exhaust grille . Ensure there is adequate space for fitting it. Air extraction with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor ...
-
Page 44: After Sales Service And Warranty
After sales service and warranty In the event of a fault which you cannot remedy yourself, please contact Miele. The contact details for Miele are given at the back of these instructions. When contacting Miele, please quote the model and serial number of your appliance. -
Page 45: Technical Data
Weight DA 3466 12 kg DA 3496 14 kg DA 3466 EXT 10 kg DA 3496 EXT 11.5 kg * For EXT models, the rated load will depend on the type of external motor fitted. Length of connection cable to external motor: 1.9 m Special accessories for recirculation mode: Conversion kit DUU 151 and charcoal filter DKF 13-1. - Page 47 Miele Australia Pty. Ltd. ACN 005 635 398 ABN 96 005 635 398 Miele Center and Head Office Melbourne: 1 Gilbert Park Drive Knoxfield, VIC 3180 Miele Center and Office Melbourne: 206-210 Coventry Street South Melbourne, VIC 3205 Miele Center and Office Sydney:...
- Page 48 DA 3466 DA 3496 DA 3466 EXT DA 3496 EXT en-AU M.-Nr. 10 122 160 / 01...