Page 2
FETCO HWD-2102 push-button commercial hot water dispensers with portion control Electrical Configurations Configuration Heater Flow Rate* Voltage Phase Wires Electrical Connection Code Configuration Draw Per hour H210210 1 X 1.4 KW 100-120 single NEMA 5-15P 12.5 3.6 Gal/13.6 liters H210220 1 X 2.1 KW...
NOTE The check and fault clear may take approximately 2 minutes for filled and preheated unit; up to 20-30 minutes for a new and empty unit. Go to fetco.com for the latest version of all information P119 User Guide HWD-2102...
When the HWD_2102 is powered on (or after controller reset) - the controls check and adjust tank level and temperature. Allow approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit. Go to fetco.com for the latest version of all information P119 User Guide HWD-2102...
Volumes above are an example at typical 0.34MPa/50PSI water pressure. Designs, materials, specifications, physical dimensions, firmware and software protocol for equipment or replacement parts are subject to review and change by FETCO without notice Go to fetco.com for the latest version of all information...
Page 6
IMPORTANT When Changing Settings, after adjusting dials, or following reassembly and plugging in: 1) Switch machine “OFF” for about ten seconds 2) Toggle back “ON” (Control Reset) . Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...
30 seconds-->the dispense will stop. Keyboard error 2 45 Seconds after the dispense stops the unit goes into keyboard error Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...
11. The HWD-2102 Hot Water Boilers provides very hot water from the faucet when it is pulled. 12. HWD-2102 may continue to dispense very hot water from the faucet after the electronic touchpad is completely disabled, or if the power is turned off, or by unplugging the unit.
1. Water supply inlet is a ⅜ inch male flare fitting. 2. The HWD-2102 Hot Water Dispenser can be connected to a cold or hot water line. (Cold water is preferred for best beverage flavor, but hot water will allow for greater output.) 4.
Page 10
Do not operate if unit has been submerged or saturated with water. Equipment exposed to flood and contaminated must not be used due to electrical and food safety. 1401.000049.00 1101.000210.00 1104.000103.00 Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...
BRACKET, ONE SHOT THERMOSTAT 1053.00004.00 THERMOSTAT, SINGLE SHOT, 25A 1024.00007.00 O-RING, DASH #344, TANK COVER 1102.00007.00 TANK COVER ASSEMBLY 1044.00004.00 LABEL, DANGER, HIGH VOLTAGE Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...
Page 12
Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...
Page 13
1025.00045.00 TUBE, 5/16" OD X 3/16" ID X 2.5" LG, PROP VALVE 1046.00035.00 LABEL, WARNING "TO REDUCE RISK OF ELECTRIC SHOCK OR FIRE" Go to fetco.com for the latest version of all information P119 User Guide HWD-2102 REVISED MARCH 2020...