Fetco L3D-10 How To Use
Fetco L3D-10 How To Use

Fetco L3D-10 How To Use

Luxus thermal dispenser

Advertisement

HOW TO USE YOUR LUXUS® THERMAL DISPENSER
Preheating or precooling of the dispenser is highly recommended. Before the first brew of the
day, fill the dispenser at least ½ way with water from the brewer. Let the water sit inside for 5-10
minutes, then drain out completely.This will extend the time that the beverage can be served at
optimum temperature.
FETCO, LUXUS, Extractor, Millenia, Pulse-Brew are all trademarks or registered trademarks of FETCO.
To open the dispenser, first unscrew the plug on the top by
turning it counterclockwise till it stops.
Next, grasp the top of the handle from the front and pull it
down completely toward you.
The dispenser is now open and ready for brewing.
To close the dispenser, move the plug and swing arm into
position with the dispenser opening.
Move the handle to its upright position. Be sure that the
handle is straight up-and-down.
Screw down the plug tightly to prevent any spillage while
carrying. The dispenser may now be transported to any
remote location.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L3D-10 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

L3d-15L3d-20

Table of Contents