Low Battery - Toshiba B-EP2DL Owner's Manual

Error Message
FLASH MEM FULL

LOW BATTERY

EXCESS HEAD TEMP
Command
example
PC001;0A00,0300,
Other error messages
****: The number of unprinted labels 1 to 9999 (in units of label)
When the printer does not operate properly
In the case of the following symptoms, please check the respective points and take corrective action.
Symptom
The printer does not turn
on by pressing the
POWER switch.
Fully charged battery is
loaded but the operating
time is short.
The printer cannot
communicate via IrDA.
The flash memory has insufficient
area for storing data.
Remaining battery capacity is low.
The print head temperature reached
the upper limit of the operating
temperature.
When a command error occurs, up
to 16 digits of alphanumeric or
error
symbol are displayed on the upper
line of the LCD.
A hardware or software failure
occurs.
Point to check (Cause)
The battery pack is not loaded
correctly.
The battery life is expired.
The printer is not turned on.
Distance to the host is too far. .
Angle of the IrDA window is not
proper.
Direct sunlight is coming into the
IrDA window
IrDA window is dirty.
Serial interface cable is connected.
(GH20 only)
The printer is communicating via
wireless communication.
(GH30/GH40 only)
Communication conditions are
incorrect.
Cause Solution
Turn off the [POWER] button, then
back to on. Send data from the host
to the printer again. If the problem
recurs, please turn off the power and
contact TOSHIBA TEC service
representative.
Turn off the printer, and replace the
battery pack with a fully charged one.
Stop printing and wait until the printer
automatically restores. If the problem
recurs, please turn off the power and
contact TOSHIBA TEC service
representative.
Turn off the [POWER] button, then
back to on. Send data from the host
to the printer again. If the problem
recurs, please turn off the power and
contact TOSHIBA TEC service
representative.
Turn off the [POWER] button, then
back to on. If the problem recurs,
please turn off the power and contact
TOSHIBA TEC service
representative.
Solution
Load a fully charged battery pack
correctly.
Load a fully charged new battery pack
correctly.
Turn on the printer.
Bring the printer close to the host so
that their IrDA windows face each
other within 10cm.
Move the printer so that the IrDA
window face that of the host.
Avoid direct sunlight.
Clean the IrDA window.
Disconnect the RS-232C cable from
the printer.
Terminate the wireless
communication.
Set the communication conditions
correctly