WEG SSW-06 Fieldbus Communication Manual page 35

Operation via Network
3 – After the command is received, the drive answers with the content of the Parameter P100 = 20. The error
bits will be reset, indicating that the read has been realized with success:
4 – The master sends a new command for writing of P102 = 50. The toggle bit value was 1, then its value is
written to 0 (zero) for indicating that a new command was sent:
5 – After the new command has been received, the drive executes the action and responds that the command
has been executed with success:
Input (drive → master)
0000h 5 th
th
0000h 6
0000h 7 th
Input (drive → master)
0011h 5 th
0066h 6 th
0014h 7 th
Input (drive → master)
0011h 5 th
th
0066h 6
0014h 7 th
Input (drive → master)
0002h 5 th
0066h 6 th
0032h 7 th
Output (master → drive)
word 0011h
word 0066h
word 0000h
Output (master → drive)
word 0011h
word 0066h
word 0000h
Output (master → drive)
word 0002h
word 0066h
word 0032h
Output (master → drive)
word 0022h
word 0066h
word 0032h
SSW-06 | 35