Warranty And Liability; Declaration Of Conformity; Environmental Protection, Disposal - Fein KBE 35 Series Original Instructions Manual

OBJ_BUCH-0000000296-001.book Page 27 Wednesday, February 7, 2018 3:47 PM
Only remove the core bit from the drilled hole while the
motor is running.
If the core bit should remain stuck in the material, stop
the drill motor and carefully turn the core bit out coun-
ter-clockwise.
Remove the chips and the drilled core after each drilling
process.
Do not touch the chips with your bare hand.
Always use a chip hook.
Danger of burning! The surface of the magnet can
reach high temperatures. Do not touch the magnet
with your bare hands.
When changing a drill bit, pay attention not to damage
the cutting edges.
When core drilling layered material, remove the core and
the chippings after drilling each layer.
Do not use the magnetic core drill unit when the cooling-
lubricant system is defective. Each time before operating,
check for tightness against leaks and for cracks in the
hoses. Prevent liquids from entering or penetrating elec-
trical components.
The magnetic core drill unit is equipped with a tempera-
ture switch. When the motor gets too warm, the magnetic
core drill unit switches off.
When the motor has cooled down, the magnetic core drill
unit can be switched on again.
To reduce the cool-down period, the motor can be
switched on by pressing and holding the ON button. Dur-
ing the cool-down period, the motor will only run while
the ON button is pressed.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
After several hours of operation, the play in the dove-tail
guide can increase. As a consequence, the drill motor can
glide alongside the dove-tail guide by itself. In automatic
machine operation, this can lead to a malfunction of the
automatic reversing feature. In this case, retighten all set
screws of the dove-tail guide correspondingly so that the
drill motor can easily be moved manually, yet does not
glide by itself (see page 16).
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available through
the FEIN customer service centre.
TThe current spares parts list for this power tool can be
found on our website at www.fein.com.
If required, you can change the following parts yourself:
Application tools, cooling-lubricant tank

Warranty and liability.

The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
Instruction Manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-DB_IA,
D-73529 Schwäbisch Gmünd

Environmental protection, disposal.

Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.
en
27