Bubble With Dmx; Clean Up - Magicfx Smokebubble Blaster User And Installation Manual

3.8

BUBBLE WITH DMX

1. Set the first 3 operational addresses (Bubble setting, Smoke setting, Fan speed)
to define the desired output, see Section 1.6.
2. Set the 4th operational address (Go trigger) to 0.
3. Make sure that each prescribed safety zone is free from persons.
4. Activate the safety address. The bubble fluid starts circulating.
5. Wait for approximately 30 seconds until the FX LED indicator lights up.
6. When it's time to bubble, activate the 4th operational address (Go trigger).
7. Enjoy the view!
8. Deactivate the fourth operational address (Go trigger) to stop blasting
bubbles.
9. Deactivate the safety address. The FX LED indicator on each machine dims
and the bubble fluid stops circulating.
3.9

CLEAN UP

CAUTION
1
Make sure that the machine is not blasting bubbles.
24 MAGICFX SMOKEBUBBLE BLASTER — User and Installation Manual
®
Walk carefully when approaching the machine. The floor can be
slippery due to spilled bubble fluids.