Table of Contents
Advertisement
3.7
SETUP MULTIPLE MACHINES IN A SEQUENCE WITH DMX
DMX IN
DMX OUT
POWER IN
POWER OUT
1. Connect a power link cable to the power output.
2. Connect the other end to the power input of the next machine.
3. Connect a DMX cable to the DMX output.
4. Connect the other end to the DMX input of the next machine.
5. Switch the machine ON (If Manual mode is ON, the machine starts bubbling
instantly).
6. Make sure that in the menu Manual mode is OFF, see Section 1.7.
7. Use the buttons or a RDM controller to assign DMX addresses, see Chapter 1.
8. Repeat step 1 – 5 for each subsequent machine.
CAUTION
5-pole male
PowerCon TRUE1 male
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
MAGICFX
SMOKEBUBBLE BLASTER — User and Installation Manual
®
DMX
5-pole female
PowerCon TRUE1 female
POWER
DMX IN
DMX OUT
POWER IN
POWER OUT
23
Advertisement
Table of Contents
