Table of Contents
Advertisement
MOUNT ADAPTER MEASUREMENT
With the vehicle on level ground, measure from the
ground to the center of the hole on the U-bracket side
plate on the mount.
The height of the mount should be 16" or less from
the center of the U-bracket hole to level ground. The
appropriate adapter plates need to be attached to the
mount adapter. (The mount adapter comes packaged
with the blade crate assembly.)
If the measured height is 16" or less, install the short
height adjustment adapter plates as described.
Center
Short
of Hole
Adapter
Plate
Mount
Adapter
Lit. No. 43664, Rev. 00
UNDERCARRIAGE INSTALLATION
Mount
16" or less
MOUNT ADAPTER INSTALLATION
Install adapter plates as follows:
1. Position the adapter plate against the driver's side
portion of the mount adapter as shown. Insert a
3/4" x 2-3/4" cap screw through the lower front
adapter plate hole and through the appropriate
hole on the mount adapter. Secure with a locknut.
Mount Adapter
3/4" Locknut
3/4" x 2-3/4" Cap Screw
2. Insert a cap screw through the rear adapter plate
hole, through the slot on the mount adapter and
through a washer. Secure with a locknut.
3. Repeat for the passenger's side. Tighten all
fasteners according to the torque chart.
NOTE: After fi ve to ten hours of snowplow usage,
retorque all undercarriage assembly fasteners.
8
3/4" Washer
Adapter Plate
November 15, 2013
Advertisement
Table of Contents
