Table of Contents
Advertisement
16.4 Wrap-Up
Once downloading is complete, close the RFU utility, move CONFIG switch #8
back to the "OFF" (up) position to exit "firmware download" mode, and cycle
power momentarily to the unit by either disconnecting the auxiliary power
supply and/or powering down all connected drives or momentarily removing all
drive communication cables from the unit.
When the unit powers up again, it will be running the new application firmware.
If the new firmware version release notes indicated that the configuration file
might need to be reloaded, then do so at this point.
When completed with RS232 port use, remove the RS232 cable and reinstall
the port dust cover to minimize contamination of the port's electrical contacts.
74
Advertisement
Table of Contents
