Toshiba RAS-B07J2KVSG-E Service Manual page 60

2. AUTOMATIC OPERATION
To automatically select cooling, heating, or fan only operation.
1. Press Press : Select Auto A.
: Select the desired temperature. Min 17°C, Max 30°C
2. Press Press
3. Press Press : Select AUTO, LOW , LOW+
3. FIREPLACE AND 8°C HEATING OPERATION
Fireplace Operation
Keep indoor unit's fan blowing continuously during thermo off, to circulate heat from other sources
over the room. There are three setting parameters: Default setting > Fireplace 1 > Fireplace 2
Fireplace 1:
During thermo off period, the indoor unit's fan will continue to run by the same speed, previously
selected by end-user.
Fireplace 2:
During thermo off period, the indoor unit's fan will continue to run at super-low speed,
programmed from factory.
8°C Heating Operation (8°C)
Heat mode operation for keep room temperature (5-13°C) with less of energy usage.
Fireplace and 8°C Heating Operation
Note:
While Fireplace operation on heating mode, indoor unit fan always runs and cold air breezing
●
might be occurred.
Fireplace and 8°C will operate in Heating mode only.
●
4. COOLING / HEATING / FAN ONLY OPERATION
1. Press Press : Select Cool
: Set the desired temperature. Min 17°C, Max 30°C
2. Press Press
Fan Only : No temperature indication
3. Press Press : Select AUTO, LOW , LOW+
Note : QUIET is ultra low fan speed for quiet operation.
5. DRY OPERATION
For dehumidification, a moderate cooling performance is controlled automatically.
1. 1. . Pre Press : Select Dry
2. Pre ss
: Set the desired temperature. Min 17°C, Max 30°C
Note : DRY Mode fan speed is set to Auto only.
)
(
FIREPLACE 1 FIREPLACE 2
Normal
operation
, Heat , or Fan only
, MED , MED+ , HIGH
8°C
, MED , MED+
- 60 -
or Quiet
HIGH or Quiet