Toshiba RAS-B07J2KVSG-E Service Manual page 112

No. Part name
3
Front panel
Electric part
4
box assembly
Procedures
1) Stop operation of the air conditioner and turn
off its main power supply.
2) Open two screw caps and securely remove
screws (2 pcs.) at the front panel.
3) Take off the hooks of front panel from top side
of the back body.
4) Slightly open the lower part of the front panel
then pull the upper part of the front panel
toward you to remove it as shown on figure.
1) Follow the procedure item 3 .
2) Remove screw holding the electric part cover.
TA sensor
TCJ sensor
Earth line
TC sensor
3) Disconnect the connectors for the fan motor
and louver motor from P.C. board assembly.
Earth screw
Earth line
Washer
4) Remove the earth screw and earth line from
evaporator.
5) Pull out TC and TCJ sensor from sensor
holder of the evaporator.
6) Remove the 2 fixing screws that secures the
electric parts box assembly, unit display
assembly and remove the electric parts box
assembly.
Fan motor connector
Louver motor connector
TC sensor
or TCJ sensor
Sensor holder
- 112 -
Remarks
Air inlet grille
Screw
Screw
Screw cap
Screw
Electric part cover
Screw
Screw
Front panel
Connectors