Toshiba RAS-B07J2KVSG-E Service Manual page 116

No. Part name
Heat exchanger
10
(Evaporator)
- Please make sure that the hook of motor cover must be
Procedures
1) Follow the procedure in item 3 and 4 .
2) Remove 2 fixing screws at the left side of
the heat exchanger.
3) Remove fixing screw at the upper right side
of the heat exchanger.
4) Remove the pipe holder from the rear side of
the main unit.
5) Pull out the right hand side until the locking
slot of heat exchanger is released from the
hook of the motor cover then pull out the
upper side of heat exchanger.
Heat exchanger
<To re-installation>
In case of evaporator is assembled with
evaporator hins seal :
- Put the evaporator hins seal on the body back
before assembly the heat exchanger.
- Please keep assembly heat exchanger
follow figure as below :
Heat exchanger
Cross flow fan
installed into the locking slot of heat exchanger.
Heat exchanger
Motor cover
Locking
slot
Hook
Heat exchanger
Evaporator hins seal
Motor cover
Locking slot
Hook
- 116 -
Remarks
Screws
Heat exchanger
Screw
Pipe holder
Heat exchanger