Toshiba RAS-B07J2KVSG-E Service Manual page 105

Split type
Hide thumbs Also See for RAS-B07J2KVSG-E:
Table of Contents

Advertisement

Diagnosis/Process flowchart
A
Replace control
board assembly.
Check
NG
compressor
winding
resistance.
OK
Replace
control board.
11-8. How to Check Simply the Main Parts
11-8-1. How to Check the P.C. Board (Indoor Unit)
(1) Operating precautions
1) When removing the front panel or the P .C. board, be sure to shut off the power supply breaker.
2) When removing the P .C. board, hold the edge of the P .C. board and do not apply force to the parts.
3) When connecting or disconnecting the connectors on the P .C. board, hold the whole housing. Do not pull
at the lead wire.
(2) Inspection procedures
1) When a P .C. board is judged to be defective, check for disconnection, burning, or discoloration of the
copper foil pattern or this P .C. board.
2) The P .C. board consists of the following 2 parts
a. Main P.C. board part :
DC power supply circuit, Indoor fan motor control circuit, CPU and peripheral circuits,
buzzer, and Driving circuit of louver.
b. Indication unit of infrared ray receiving infrared ray receiving circuit, LED :
To check defect of the P .C. board, follow the procedure described below.
Item
Check
B
Operation
Replace
compressor.
Contents
Check winding resistance
between phases of compres-
sor, and resistance between
outdoor frames by using a
tester.
• Is not grounded.
• Is not short-circuited
between windings.
• Winding is not opened.
Remove connector CN31 of
the outdoor fan motor, turn
on the power supply breaker,
and perform the operation.
(Stops though activation is
prompted.)
Check operation within 2
minutes 20 seconds after
activation stopped.
- 105 -
Summary
→ OK if 20MΩ or more
→ OK if about
2.18Ω for RAS-07,10J2AVSG-E
2.35Ω for RAS-13J2AVSG-E
1.57Ω for RAS-16J2AVSG-E
→ (Check by a digital tester.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents