Interconnecting Several Showlasers (Master/Slave Operation); Remote Control - EuroLite LED LASER DERBY User Manual

Interconnecting several showlasers (master/slave operation)

Several showlasers may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The units must be set to the corresponding operating
modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until Addr
is indicated in the display. Confirm with the ENTER button. Use the UP and DOWN buttons to set the start
address to A001.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected
in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input
of the master unit.
3 Set the master unit to the desired show program. The interconnected showlasers will now operate in sync.
When actuating a button, always hold the remote control in the direction of the sensor at the unit's front. There
must be visual connection between the remote control and the sensor. In DMX and slave modes, the remote
control is disabled.
Button
Stand By
DMX
Show 1
Show 2
Show 3
Show 4
Show 5-8
LED Color
LED Random
Laser Color
LED Random
Sound ON
Sound OFF
Speed –
Speed +
Notes
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
• If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and at
the same time remove the battery support. For operation, one 3 V button cell type
CR 2025 is required. When inserting, pay attention that the positive pole of the button
cell shows upwards in the support.

REMOTE CONTROL

Function
LEDs and laser beams on/off
DMX mode
Show program 1: LED derby
Show program 2: laser
Show program 3: LED derby + laser
Show program 4: LED derby + laser with changing running speed
no function
Color selection for the LED beams. Change colors (15) by pressing
repeatedly.
LED beams with random colors
Color selection for the laser beams. Change colors (3) by pressing
repeatedly.
Laser beams with random colors
Enables sound control for show programs 1-4. Set the microphone
SENSITIVITY on the unit (SENSITIVITY L-HI).
Enables automatic mode for show programs 1-4. Set the running speed
with Speed –/+.
Running speed show program 1-3 in automatic mode down
Running speed show program 1-3 in automatic mode up
24 • EN