Table of Contents
Advertisement
Available languages
Available languages
Stand-alone mode
A few seconds after connection to the mains, the effect spotlight is ready for operation and the previously
selected operating mode is activated. During the start-up process, the software version is briefly displayed
(V1x.xx)
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1
Press the MENU button so many times, until you reach the top menu level (Addr, chAn, ModE, SEt,
inFo). Now select with UP and DOWN the menu item ModE. Confirm with the ENTER button and select
with the UP and DOWN buttons the submenu "Soun" (the display Led "Soun" light green).
2
Use the buttons UP and DOWN to select the desired show program between SP01 and SP08. Confirm
with the ENTER button.
3
Use the UP and DOWN buttons to set the rotation of the program from r cw – rccw. Confirm with the
ENTER button.
4
Use the UP and DOWN buttons to set the rotation speed of the program from Sn00-Sn99. Confirm with
the ENTER button.
5
Use the UP and DOWN buttons to set the brightness between di00-di99. Confirm with the ENTER
button.
6
Adjust the microphone sensitivity to the volume of the music with the SENSITIVITY control (MIN / MAX).
The LEDs will be switched off after a few seconds if the volume is too low or if there is no sufficient bass
beat.
Interconnecting several devices (master/slave operation)
Press the MENU button so many times, until you reach the top menu level -Taste, (Addr, chAn, ModE, SEt,
inFo). Now select with UP and DOWN buttons the menu item ModE. Confirm with the ENTER button and
select with the UP and DOWN buttons the submenu "SLAU" (the display Led "Slave" light yellow).
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated on the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
Automatic mode
In automatic mode 8 show programs are available that run at an adjustable speed.
1
Press the MENU button so many times, until you reach the top menu level (Addr, chAn, ModE, SEt,
inFo). Now select with UP and DOWN the menu item ModE. Confirm with the ENTER button and select
with the UP and DOWN buttons the submenu "Auto" (the display Led "Auto" light blue).
2
Use the buttons UP and DOWN to select the desired show program between Au01 and Au08. Confirm
with the ENTER button.
3
Use the buttons UP and DOWN to select the program speed of the program from SP00 and SP99.
4
Use the UP and DOWN buttons to set the rotation of the program from r cw – rccw. Confirm with the
ENTER button.
5
Use the UP and DOWN buttons to set the rotation speed of the program von Sn00-Sn99. Confirm with
the ENTER button.
6
Use the UP and DOWN buttons to set the brightness between di00-di99. Confirm with the ENTER
button.
27/36
00143647, Version 1.1
Advertisement
Table of Contents
