Replacing The Operator Panel Kb Pcb - SATO S84 ex Service Manual

5.6 Replacing the Operator Panel KB PCB

Required tool:
• Phillips screwdriver
1
Make sure that the printer is in power off mode, then disconnect the power cord from
the AC outlet.
2
Remove two screws  attaching the
operator panel assembly  to the center
frame.
3
Disconnect the connector  on the rear of
the operator panel assembly .
4
Remove four screws
operator panel KB PCB
operator panel assembly
5
Press the catch on the right side of
operator panel assembly
remove the operator panel KB PCB
Replace the defective operator panel


KB PCB with a new operator panel
KB PCB.
6
Perform the assembly with the reverse
procedure.
After replacement
• Adjust the print darkness.
Refer to Adjustment of the Print Darkness in chapter 5 of S84-ex/S86-ex operator manual.
• Adjust the pitch.
Refer to Adjusting the Print Position in chapter 5 of S84-ex/S86-ex operator manual.
• Adjust the offset.
Refer to Adjusting the Media Stop Position in chapter 5 of S84-ex/S86-ex operator manual.
• Adjust the buzzer volume.
Refer to Adjusting the Buzzer Volume in chapter 4 of S84-ex/S86-ex operator manual.
• Adjust the display brightness.
Refer to Adjusting the Display Brightness in chapter 4 of S84-ex/S86-ex operator manual.

, attaching the

to the

.

and

.
5 Replacement
4
S84-ex/S86-ex Service Manual
3
2
1
2
5
75