Using Debug Mode - ADC SG-1 User Manual

Chapter 6: First-Level Commands
U D M
SING EBUG ODE
This section provides information on the commands and options available in debug mode.
Switching to Debug Mode
Host> debug
Use the debug command at the first-level prompt (Host>) to switch the system to the second-level debug prompt:
Host(debug)#. This prompt indicates that the user is now in the second-level debug mode and has access to the
five second-level commands in the debug menu.
Usage
Step
1 Use the show command to display memory, system and fragmentation information.
2 The port sonet source-clock command determines timing configuration for the ATM port specified.
3 At this level, the exit and end commands will return the user to the first configuration level.
4 From the Host> prompt, enter the debug command in the following format:
debug
Parameter(s)
None.
Example(s)
Host(debug)# ?
show
port
port-ethernet
radius-server
clear
exit
end
Host(debug)#
6-34
Action
- Display debug parameters
- Select a port to configure
- Port ethernet interface
- radius server command
- Clear arp table
- Exit current level
- Return to first level
June 30, 2006
SG1-UM-8500-03