L2Tp And Ppp Commands - ADC SG-1 User Manual

Chapter 7: Second Level Commands
L2TP PPP C
AND OMMANDS
The L2TP commands are used for configuring the L2tp source-address. When the l2tp source-address is
configured, the system sets the l2tp source address in the response packets regardless of the original l2tp LAC
request.
Only one source interface may be defined.
Using the ip l2tp source-address command
Host(config)# ip l2tp source-address
This command deletes the radius source-interface configuration by setting it to its default value.
Usage
ip l2tp source-address <IP address>
Parameter(s)
<IP address>
This is the l2tp source IP address; it must be a legal IP address.
Example(s)
Host(config)# ip l2tp source-address 192.168.1.2
Using the no ip l2tp source-address command
Host(config)# no ip l2tp source-address
This command deletes the L2TP source-address configuration.
Usage
no ip l2tp source-address
Example(s)
Host(config)# no ip l2tp source-address
Defining the domain name
Host(config)# ip domain-name
Usage
ip domain-name <valid domain name>
Example(s)
Host(config)# ip domain-name My-Company
7-40
June 30, 2006
SG1-UM-8500-03