ADC SG-1 User Manual page 33

June 30, 2006
Parameter(s)
<slot number>\<port number>
The SCC and rear I/O interfaces have specific designations as shown in
Card/Type
Rear I/O
Gigabit Ethernet
ATM/GiG-E Card
ATM
GiG-E
<ipaddr>
The SCC IP address for interface in question. This address is set up to be on the same subnet as the Ethernet
network to which the SG-1 system is attached (format xxx.xxx.xxx.xxx).
<netmask>
The subnet mask associated with the SCC IP address. This address is based on the Ethernet network to which the
SG-1 system is attached (format xxx.xxx.xxx.xxx).
<mode>
10H
10F
100H
100F
1000H
1000F
Auto
Example(s)
Host> configure terminal
Host(config)# interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500
Added Item
SG1-UM-8500-03
Table 4-2. Interface Identification
Slot/Port 1
1/1
1/1
2/1
1/1
Table 4-3. Ethernet Mode
Value
10M half-duplex
10M full-duplex
100M half-duplex
100M full-duplex
1000M half-duplex
1000M full-duplex
Auto select mode
Chapter 4: Accessing the Command Line Interface
Table 4-2.
1/2
1/2
2/2
1/2
Explanation
Slot/Port 2
4-3