Overview - ADC SG-1 User Manual

SG-1 V
ENDOR
This appendix describes the vendor-specific attributes related to SG-1 EDS architecture.
O
VERVIEW
The vendor-specific attributes are based on RFC-2865 RADIUS recommendation. The first 4 octets are the vendor
id (supported vendor ID 2454, 2014). The next two octets are the vendor-type and length as recommended in the
RFC.
The attributes are split into the following groups:
• User
• DHCP
• protocol
• service
• route
• vpdn
• qos
• DNS
Vendor-Specific Attributes Table
When the system sends a vendor-specific attribute to the radius, it sets the vendor type with the attribute internal
number, as specified below in the vendor-specific attribute list
Num Attribute Name
1 accounting
2 orig-name
3 auth-type
4 action
5 SSC-host
SG1-UM-8500-03
-S A
PECIFIC TTRIBUTES
Table A-1. Vendor-Specific Attribute List
Attribute
Value (1 byte
which takes
Attribute value of
Group 1 to 255)
user
user
user
user
user
(Table A-1).
First
Introduced
10 V5.0
12 V5.0
13 V5.0
14 V5.0
15 V5.0
Appendix
Description
Allows defining the session
accounting operation mode and
methodology.
Contains the original user name as
received during PPP negotiation.
Contains the authentication type of
the Access Request message. It
provides the RADIUS with additional
information regarding the purpose of
the authentication.
Defines the action that should be
taken by the system.
Contains the SSC (Service
Selection Center) host IP address at
which the user activated the service.
A
A-1