ADC SG-1 User Manual page 122

Chapter 7: Second Level Commands
<mask>
The mask of the network allowed connecting the LNS.
<alpha-numeric string>
Password used for authenticating between LAC and LNS.
Example(s)
Host(config)# tunnel-server host 12.25.3.15 mask 255.255.255.0 password rewed
Setting multi-link mode
Host(config)# multilink-mode
The SG-1 allows the user to use higher bandwidth by using ML-PPP. Typically ML-PPP is used to combine the
speed of a few ISDN BRI B-Channels to get 128 Kbps or other N x 64 Kbps of virtual bandwidth, depending on the
RADIUS database and the SG-1 configuration.
Usage
multilink-mode <multi-cage | single-cage | none>
Parameter(s)
This command has the following options:
• multi-cage–ML-PPP uses PPP projection to call master method. The port limit is received from the RADIUS.
If no port limit is defined, the system default is 1 (according to the RFC). This means 64 Kbps is the maximum
bandwidth (none mode behavior). This is for a scenario of various SG-1SCC cards in a POP.
• single-cage–ML-PPP uses PPP projection to call master method. The port limit is received from the RADIUS.
If no port limit is defined, the system default is 1 (according to the RFC). This means 64 Kbps is the maximum
bandwidth (none mode behavior). The difference with the Multi-Cage option is the efficiency of the bundling
(in this scenario there is only one SCC card).
• none–no Multi link operation is allowed in the SG-1. All the PPP links port limit definitions are 1. This means
the MLP protocol negotiation is allowed (MLP user), but only one link is available.
Defining an address pool
Host(config)# ip local-pool
The ip local pool command allows you to define IP pools for all the incoming sessions. There are three required
command line arguments-the pool name, the starting IP address in the pool, and the last IP address in the pool.
Usage
ip local-pool <pool_name> <starting_IP> <last_IP> <internal | external>
7-42
June 30, 2006
SG1-UM-8500-03