Advertisement
Quick Links
TOYOTA
Preparation
Part Number: PT278-42130
Kit Contents
Item #
Quantity Reqd.
1
1
2
1
3
1
Hardware Bag Contents
Item #
Quantity Reqd.
1
1
2
1
3
1
4
1
5
1
6
4
7
2
Additional Items Required For Installation
Item #
Quantity Reqd.
1
2
3
Conflicts
Recommended Tools
Personal & Vehicle
Protection
Safety Glasses
Safety Gloves
Vehicle Protection
Wrist & Belt Buckle
Protection
Special Tools
Installation Tools
Tape Measure (Metric)
Non-Intrusive Infrared Temp
Probe/Gun
Heat Gun
Special Chemicals
Cleaner
General Applicability
Issue: C 1/25/2013
RAV4
Description
Crossbar Assembly Front (long)
Crossbar Assembly Rear (short)
User's Manual
Description
Front LH Side Lower Clamp
Front RH Side Lower Clamp
Rear LH Side Lower Clamp
Rear RH Side Lower Clamp
Lever Key
Lever Assembly with t-bolt
Forward Limit Label
Description
Notes
Cloth
Notes
Notes
Notes
Approved Cleaner
Page 1 of 4 pages
2013 -
Recommended Sequence of Application
Item #
Accessory
1
2
3
Vehicle Service Parts
Item #
Quantity Reqd.
1
2
3
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.
CROSSBAR KIT
*Mandatory
(may be required for reassembly)
Description
Advertisement
Related Manuals for Toyota PT278-42130
Summary of Contents for Toyota PT278-42130
- Page 1 TOYOTA RAV4 2013 - CROSSBAR KIT Preparation Part Number: PT278-42130 Kit Contents Recommended Sequence of Application Item # Quantity Reqd. Description Item # Accessory Crossbar Assembly Front (long) Crossbar Assembly Rear (short) User’s Manual *Mandatory Hardware Bag Contents Vehicle Service Parts...
- Page 2 Safety (eye protection, rechecking torque procedure, etc.). Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). Please see your Toyota dealer for a copy of this document. 1. Affix front crossbar “Forward Limit” Fig. 1-1 83mm Front of warning labels to side rails.
- Page 3 TOYOTA RAV4 2013 - CROSSBAR KIT Procedure 3. Install Lower Clamps Fig. 3-1 Tighten (a) Verify proper clamps prior to installation by looking for position markings on top of clamp. (4 places) (Fig. 3-1) (b) Carefully position clamp underneath side rail under cross bar support.
- Page 4 TOYOTA RAV4 2013 - CROSSBAR KIT Checklist - these points MUST be checked to ensure a quality installation. Check: Look For: Accessory Function Checks Front crossbar should not be forward of Ensure crossbars are secure and in correct warning label.
Need help?
Do you have a question about the PT278-42130 and is the answer not in the manual?
Questions and answers