Dotcode - Omron MicroHAWK V320-F User Manual

Appendices
G-19 DotCode
• Important: When DotCode is enabled, no other symbologies will be decodable. You must disable DotCode to decode
symbols of any other type.
G-19-1 DotCode Status
Serial Cmd:
Default:
Options:
Disabled
The reader will not attempt to decode DotCode symbols.
Enabled
The reader will attempt to decode DotCode symbols.
G-19-2 Rotation Mode
Serial Cmd:
Default:
Options:
No Rotation
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
Low Rotation
The reader will decode +/– approximately 10 degrees from the horizontal or vertical symbols. It is
slightly slower than the No Rotation option.
OmniDirectional
The reader will support 360 degree reading. Omnidirectional is significantly slower than the other two
options.
G-30
<K497,status,rotation mode>
0 = Disabled
0 = Disabled
1 = Enabled
<K497,status,rotation mode>
0 = No Rotation
0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual