Activate Account Management - Omron MicroHAWK V320-F User Manual

6-12 Activate Account Management

Activate Account Management allows you to set a password that will be required to open any session
of WebLink. An Administrator can create, update, and delete users from an Administrator user
interface. While management is active, every user must log in with a username and password
established by the Administrator to use WebLink. There are three different user types, each with a
different privilege level that determines their access:
• Administrator (Full Access as well as the ability to manage user accounts and enable or disable
Account Management)
• Controller (Full Access)
• Monitor (View-Only Access)
Click the gear icon at the upper right of the WebLink user interface to open the Application Settings menu.
Then click Activate Account Management to open the dialog shown below.
Enter and verify a new username and password and then click Activate Account Management to
password-protect the WebLink configuration.
The Activate Account Management button brings up a dialog allowing you to create an Administrator
account and to Activate Account Management. This is the same account information that you will use to
log in to the application later, so be sure to remember it. After entering valid credentials, click the blue
Activate Account Management button. Clicking this button will create the Administrator account and
will restart the application.
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
6 Application Settings
6-19
6