Mitsubishi Electric FR-LU08 Instruction Manual page 3

Caution
Transportation and mounting
 The mounting orientation must be correct.
 The surrounding air temperature must be between -10 to +50°C (non-freezing). Otherwise the inverter may be damaged.
 The surrounding humidity must be 90% RH or less (non-condensing) for the FR-LU08, and 95% RH or less (non-condensing) for the FR-LU08-01. Otherwise the
inverter may be damaged.
 The storage temperature (applicable for a short time, such as during transit) must be between -20 to +65°C. Otherwise the inverter may be damaged.
 The inverter must be used indoors (without corrosive gas, flammable gas, oil mist, dust and dirt etc.) Otherwise the inverter may be damaged.
 Do not use this product at an altitude above 2500 m. Vibration should not exceed 2.9 m/s
damaged.
 If halogens (including fluorine, chlorine, bromine, and iodine) contained in fumigants for wood packages enter this product, the product may be damaged. Prevent
the entry of fumigant residuals or use an alternative method such as heat disinfection. Note that sterilization of disinfection of wood packages should be performed
before packing the product.
Trial run
 Before starting operation, each parameter must be confirmed and adjusted. A failure to do so may cause some machines to make unexpected motions.
Warning
Usage
 Since pressing the STOP/RESET key of the operation panel may not stop output depending on the function setting status, separate circuit and switch that make an
emergency stop (power OFF, mechanical brake operation for emergency stop, etc.) must be provided.
 OFF status of the start signal must be confirmed before resetting an inverter fault. Resetting an inverter fault with the start signal ON restarts the motor suddenly.
 Do not modify the equipment.
 Do not perform parts removal which is not instructed in this manual. Doing so may lead to fault or damage of the product.
Caution
Usage
 When parameter clear or all parameter clear is performed, the required parameters must be set again before starting operations because all parameters return to
the initial value.
 Static electricity in your body must be discharged before you touch the product.
Disposal
 The product must be treated as industrial waste.
 Many of the diagrams and drawings in this Instruction Manual show the inverter without a cover or partially open for explanation. Never operate the inverter in this
manner. The cover must be reinstalled and the instructions in the Instruction Manual must be followed when operating the inverter.
2
at 10 to 55 Hz in X, Y, and Z directions. Otherwise the inverter may be
General instruction
3