Account /Intercom Settings - Grandstream Networks WP810 Administration Manual

Auto Answer
Refer-To Use Target
Contact
Blind Transfer Wait
Timeout
Key As Send
RFC2543 Hold
Disable Call Waiting
Ringtone
Ring Timeout

Account /Intercom Settings

Allow Auto Answer by
Call-Info/Alert-Info
Allow Barging by Call-
Info/Alert-Info
Custom Alert-Info for
Auto Answer
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. Default setting is "No".
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
Defines the timeout (in seconds) for waiting SIP frag response in blind
transfer. Valid range is 30 to 300.
Allows users to configure either the "*" or "#" keys as the "Send" key. Please
make sure the dial plan is properly configured to allow dialing * and # out.
The default setting is "Pound (#)".
Allows users to toggle between RFC2543 hold and RFC3261 hold. RFC2543
hold (0.0.0.0) allows user to disable the hold music sent to the other side.
RFC3261 (a line) will play the hold music to the other side.
Enables / disables the call waiting feature for the current account. When set
to "Default", global call feature setting will be used. Default setting is Default.
Defines the timeout (in seconds) for the rings on no answer. The default
setting is 60. The valid range is from 10 to 300.
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep, based on the SIP Call-
Info/Alert-Info header sent from the server/proxy.
When enabled, the phone will automatically put the current call on hold and
answer the incoming calls based on the SIP Call-Info/Alert-Info header sent
from the server/proxy. However if the current call was answered based on
the SIP Call-Info/Alert-Info header, then all other incoming calls with SIP Call-
Info/Alert-Info headers will be rejected automatically.
Used exclusively to match the contents of the Alert-Info header for auto
answer. The default auto answer headers will not be matched if this is
defined.
WP810 Administration Guide
Version 1.0.1.1
P a g e | 44