Sealing The Bag Early - Miele EVS 7110 Operating And Installation Instructions

If you notice during the vacuuming
process that liquids are threatening
to spill out, you can end the process
and seal the bag early (see
"Operation – Sealing the bag early").
After the vacuuming process
A signal sounds.
 Open the glass lid.

Risk of burning due to hot
surfaces.
The sealing bar and weld seam are
hot.
Do not touch the sealing bar or the
weld seam immediately after the
vacuuming process.
 Remove the vacuum sealing bag from
the vacuum chamber.
Before starting a new vacuuming
process, check that the vacuum
chamber and the sealing bar are
clean and dry.
Remove any soiling or liquid residues
if necessary.

Sealing the bag early

You can end the vacuuming process
before reaching the selected vacuuming
level and seal the bag early.
 Touch the  sensor.
The vacuum process stops. After a few
seconds the bag will be sealed.
Successful sealing of the bag is only
possible when there is a minimum
vacuum (vacuum level 1) in the
chamber.
Touch the  sensor again if the
required vacuum level has not yet
been reached. For technical reasons, a
few seconds will elapse before the
bag is sealed.
Operation
23