Pelgrim IKM640 Manual page 69

6 Faults uw espressomachine
PROBLEM CAUSE
Ground coffee is being Too much ground coffee
used (not beans) and the has been added.
appliance does not deliver
the coffee.
The button
been pressed and the
appliance has used both
the ground coffee added
and the coffee ground by
the mill.
Ground coffee has been
added when the appliance
is off.
The coffee does not run The holes in the spouts are
out from the spouts, but clogged with dry coffee.
from around the service
door.
The mobile container
inside the service door is
blocked and cannot swing.
134
SOLUTION
Remove the infuser and
thoroughly clean the
inside of the appliance, as
described in 4.1.1 and 4.1.2
on pages 122, 123 and 124.
Repeat the operation using
a maximum of 2 measures
of ground coffee.
has not Thoroughly clean the
inside of the appliance, as
described in 4.1.1. on page
122. Repeat the operation,
fi rst pressing the button
as described in
chapter 3.2.5 on page 117.
Remove the infuser and
thoroughly clean the
inside of the appliance, as
described in 4.1.1 and 4.1.2
on pages 122, 123 and 124.
Repeat the operation, but
fi rst switch the appliance
on.
Scrape the holes with a
needle (see chapter 4.1.1
on page 122, fi g. 20).
Thoroughly clean the
mobile container,
particularly near the hinges
to ensure they are free to
swing smoothly.
7 Installation instructions uw espressomachine
7.1 Important matters
• After removing the packaging, make sure the product is complete and undamaged.
If in doubt, do not use the appliance and contact a qualifi ed professional.
• Installation must be carried out by a qualifi ed techncian and in compliance with
current regulations.
• Packing elements (plastic bags, polystyrene etc) must not be left within reach of
children as they may represent a hazard.
• Never install the appliance in environments where the temperature may reach 0 °C or
lower (the appliance may be damaged if the water freezes).
• Make sure the mains voltage corresponds to the voltage indicated on the appliance
rating plate. Connect the appliance to an effi ciently earthed socket with a minimum
current rating of 10 A only. The manufacturer may not be considered liable for
possible incidents caused by the failure to adequately earth the mains.
If the power socket does not match the plug on the appliance, have the socket
•
replaced with a suitable type by a qualifi ed professional.
The power socket have to remain visible after installation.
•
Do not use multiple plug adapters or extension leads.
•
The power cable on this appliance must not be replaced by the user as this operation
•
requires the use of special tools. If the cable is damaged or requires replacing,
contact an authorised service centre only to avoid all risks.
• For the electrical connection use a HO5 VV-F type cable as indicated in the table
below:
Conductors
230 V ~+ ~
• You should personalise water hardness as soon as possible following the instructions
in paragraph 4.2.6 on page 128.
Amount x size
3 x 1.0 mm 2
135