Download Print this page

Pelgrim IKM640 Manual page 61

Advertisement

Available languages

Available languages

3 Use
3.
Lift the central lid and place one or two levels measure of
ground coffee in the funnel (see fi g. 13). Close the lid, push
the appliance to replace it and proceed as described in
paragraph 3.2.1 on page 113 ('Preparing coffee').
3.2.6 Notes
You can make just one or two coffees at a time by pressing the button
only once or twice (within 3 seconds).
Never add the ground coffee when the appliance is off to avoid it being dispersed
inside the appliance.
Never add more than two levels measured scoop, otherwise either the appliance will
not make the coffee, the ground coffee will be lost inside the appliance, dirtying it, or
the coffee will run off in drips and the message GROUND TOO FINE ADJUST MILL
AND PRESS OK will be displayed. A little water comes out from the steam spout.
When dosing the quantity of coffee to be added, use the measure supplied only.
Use ground coffee for espresso coffee makers only. Do not use coffee beans, freeze-
dried coffee or other materials that could damage the appliance.
If the funnel blocks due to moisture inside the appliance
or if more than two measuring scoops of pre-ground coffee
has been used, use a knife to push the coffee down (fi g. 14).
Then remove and clean the infuser and appliance as
described in paragraph 4.1.1 and 4.1.2 on pages 122, 123
and 124.
118
3 Use
Once the coffee has been delivered, to go back to making coffee using beans,
deactivate the ground coffee function by pressing the button
is enabled for operation again).
3.2.7 Hot water delivery
Always make sure the appliance is ready.
1.
Move the cappuccino maker towards the centre of the
appliance and place a container under it (fi g. 15, position 3).
13
,
or
2.
Press the button
3.
Press the button
4.
Hot water runs off from the cappuccino maker and starts to fi ll the container
underneath. You should not run off hot water for more than 2 minutes at a time.
5.
To interrupt the hot water delivery, press the button
cappuccino maker in the original position near the centre of the appliance.
3.2.8 Preparing cappucinos (using steam)
1.
Move the cappuccino maker outwards and place an empty cup under the
cappuccino maker (fi g. 15, position 2).
2.
Press the steam button
3.
Press the
until steam only is given off.
4.
To interrupt the steam delivery, press the steam button
5.
Empty the container. Then fi ll it with about 100 ml of milk for each cappuccino to be
prepared. In choosing the size of the container, bear in mind that the milk doubles
or triples in volume. You are recommended to use semi-skimmed milk at refrigerator
14
temperature.
. The appliance displays HOT WATER PRESS OK.
(OK) again to confi rm.
. The appliance displays STEAM PRESS OK.
OK button. Allow the steam mixed with water to run off for a few seconds
again (the coffee mill
3
2
1
15
again and place the
again.
119

Advertisement

loading