Pelgrim IKM640 Manual page 60

3 Use
When proceeding, always completely extract the drip tray,
to avoid that it falls when removing the grounds container
(fi g. 10). Empty the grounds container and clean thoroughly,
making sure all residues deposited on the bottom are
removed.
When removing the drip tray, the grounds container must be emptied, even if it is
not completely full. If this is not done, when next making coffee the grounds in the
container may exceed the maximum level and block the appliance.
While the appliance is running off coffee, never remove the water tank. If it
is removed, the appliance will not be able to make the coffee. If the appliance
malfunctions, do not contact the service centre straight away. The problem can
almost always be resolved by following the instructions indicated on pages 130 until
134. If this is not the case, or for further explanations, contact the customer service.
3.2.3 Changing the quantity of coffee in the cup
The appliance is factory preset to automatically deliver the following
quantities of coffee:
• Short (when the button is pressed);
• Standard (when the button
• Long (when the button is pressed);
To change these quantities, proceed as follows:
1. Press the button corresponding to the quantity you want to change (
) for at least 8 seconds until the message PROGRAM QUANTITY is displayed.
2. When the coffee in the cup reaches the required level, press the same button again
to memorise the new amount.
116
is pressed);
,
3 Use
3.2.4 Regulating the coffee mill
However, after making the fi rst coffees, if you fi nd that the
coffee delivery is either too fast or too slow (in drips), the
grinding coarseness regulator can be adjusted (fi g. 11).
The grinding coarseness regulator must only be turned
when the coffee mill is on.
Turning it 1 click (1 number) clockwise speeds up the coffee
10
delivery (without drips). Turning it 1 click anticlockwise slows
down the delivery, giving a creamier appearance to the coffee.
These adjustments will only be evident after at least 2 cups of
coffee have been run off.
Turn anticlockwise to obtain fi ner ground coffee, slower
•
delivery and a creamier appearance.
Turn clockwise for coarser ground coffee and faster delivery (not a drop at a time).
•
3.2.5 Preparing espresso coffee using ground coffee (instead of beans)
1. Press the button
mill function. The appliance displays READY PRE-GROUND.
2. Extract the appliance by pulling it outwards taking care to
use the special handles (fi g. 12).
or
to select the ground coffee function. This disables the coffee
11
12
117