Pelgrim IKM640 Manual page 64

4 Maintenance
8. After having heard the click, check that the red buttons have
snapped out, otherwise the door cannot be closed.
º The two red buttons have snapped out correctly
(CORRECT, fi g. 25).
º The two red buttons have not snapped out
(WRONG, fi g. 26).
Notes
If the infuser is not inserted correctly until it clicks into place and the two red buttons
•
have not snapped out, the service door cannot be closed.
• If it is hard to insert the infuser, before inserting it squeeze
it to the right size by pressing it forcefully from the top and
bottom simultaneously, as shown in fi g. 27.
• If it is still hard to insert the infuser:
º Leave it out of the appliance, place the drip tray, close the service door, switch
the main switch on the back of the appliance to 0 and then to l again.
º Wait for all the lights to go off, then open the door, remove the drip tray and
replace the infuser.
º Replace the drip tray, complete with the grounds container.
º Close the service door.
124
4 Maintenance
4.2 Changing and setting the menu parameters.
The following menu parameters and functions can be changed by the user:
• Clock;
• Auto-start time;
• Descaling process;
• Coffee temperature;
• Length of time the appliance remains on;
25
• Water hardness;
• Factory default values.
4.2.1 Setting the clock
To set the clock, proceed as follows:
1. Press the
displays CLOCK.
2. Press the
26
the time is changed rapidly).
3. Press the
4. Press the
parameters.
5. When the appliance is in stand-by, you can see the hour by pressing one of the
buttons (except the on/off button).
4.2.2 Setting auto-start time
This enables the time the appliance will come on automatically to be programmed.
1. Make sure the clock on the appliance is set as described above.
27
2. Press the
displays START TIME.
3. Press the
button down, the time is changed rapidly).
4. Press OK to confi rm the value.
5. Press NEXT once and the appliance displays the message AUTO-START NO.
6. Press the
START YES).
7. Press the
8. Press the
change other parameters.
MENU button then press the NEXT button repeatedly until the appliance
CHANGE button to set the clock. (If you hold the CHANGE button down,
OK button to confi rm the value.
MENU button to exit the programming mode or NEXT to change other
MENU button then press the NEXT button repeatedly until the appliance
CHANGE button to set the auto-start time. (If you hold the CHANGE
CHANGE button to modify the function (the appliance displays AUTO-
OK button to activate auto-start.
MENU button to exit the programming mode or the NEXT button to
125