Coolant Level Inspection / Filling - Sym Maxsym TL TL 500 Owner's Manual

Coolant Level Inspection / Filling

This scooter is filled with high quality coolant that is designed for the cooling system in the factory. It contains
a 50% solution of ethylene glycol based antifreeze. Position the scooter on level ground and in an upright
position. The coolant inspection window ○
level must be between the "F" ○
mark.
 Pull up the tip of the right front floor panel mat ○
 Open the reserve tank cap ○
 Reverse the above steps to restore.
NOTE :
 You can add soft water to the coolant reserve tank in an emergency, it must be restored to the correct
mixture ratio afterwards.
 If you have to add coolant often, the cooling system may have a leakage problem, have your scooter
checked by an authorized SYM dealer.
WARNING:
 Never remove the radiator cap when the engine is hot.
can be seen on the right side of the under spoiler. The coolant
A
and "L" ○ marks. Top up the coolant carefully when the level is at the "L"
a
b
○
A
A
to fill in coolant.
A
○
a
○
b
and remove the maintenance cap ○
○
B
○
A
○
A
36
from its tip.
B