Advertisement
Quick Links
PSD-VHS
TABLE TOP STAND
Step 1
Place the monitor on a soft and flat surface. Install the mounting
bracket to the plasma using the hardware supplied.
Step 2
Choose the place were the monitor would be located. Place the stand
on top of the table top. Install the (PDB-UWFB) Universal Wall Flat
Bracket (make sure that the arrow from the plate is facing up) to the
stand by using the four (4) M10 Slotted Hex Bolts (supplied).
Step 3
Mount the display to the stand (3 people required) hold the stand from
the back. Raise the display and insert the openings from the mounting
bracket to the slip lock flanges from the PDB-UWFB. Once insert
push to the left and down to lock.
www.touchboards.com 205 Westwood Ave.Long Branch, NJ 07740 1-866-942-6273 Sales@touchboards.com
Advertisement
Related Manuals for Touchboards PSD-VHS
Summary of Contents for Touchboards PSD-VHS
- Page 1 Raise the display and insert the openings from the mounting bracket to the slip lock flanges from the PDB-UWFB. Once insert push to the left and down to lock. www.touchboards.com 205 Westwood Ave.Long Branch, NJ 07740 1-866-942-6273 Sales@touchboards.com...
- Page 2 If not, the ceiling must be reinforced. Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury. Description PSD-VHS Stand PSD-UWFB Universal Wall Flat Bracket Mounting Bracket Hardware D. Flat Mounting Bracket...