Mercury SC 1000 Operation And Maintenance Manual page 43

PRECISE SPEED CONTROL CALIBRATION
NOTE: Cruise control is only available with 2007 and newer DTS engines.
30
20
10
0
b
SMART
TOW ON
There are two modes of cruise control: "RPM MODE" and "SPEED MODE."
Set the cruise control to "SPEED MODE" with the Speedometer. Launch
control will inherit the mode of control selected.
IMPORTANT: Disengage Cruise/Smart Tow before making changes between
"SPEED MODE" and "RPM MODE."
Press and hold the "SELECT" button for approximately three seconds to toggle
between "SPEED MODE" and "RPM MODE."
ENGAGING THE CRUISE CONTROL
1. Press either the "+" or "–" button to bring up the cruise control display
screen.
2. Set the speed to 10 MPH.
3. Press "+" and "–" button simultaneously to engage the cruise control.
When the throttle is in the wide‑open throttle position, the engine RPM will
increase until the set speed is attained.
4. After cruising at 10 MPH for 20 seconds, increase the speed 1 MPH.
5. After cruising at 11 MPH for 20 seconds, increase the speed 1 MPH.
6. Continue this speed increment process until the craft has reached its
maximum speed.
CANCELING THE CRUISE CONTROL
To cancel the cruise control: press the "+" and "–" buttons simultaneously.
When the cruise control is disengaged, it will remember the set speed. It will
return to that speed when the cruise control is engaged and the throttle is
positioned beyond the set cruise speed.
eng
SMART TOW
40
50
60
70
80
SPEED
10
CRUISE
MPH LAUNCH
+ / - TO DISENGAGE
a - Increase set cruise speed
b - Decrease set cruise speed
c - Set cruise speed
a
c
53435
39