Mercury SC 1000 Operation And Maintenance Manual page 31

NOTE: Depending on the engine model and vessel options, not all screens will
apply.
ESTIMATED RANGE
6
7
RESET
42.3
8
9
RESET
- - - - - -
10
11
- - -
GAL
STEERING ANGLE
12
6. Estimated Range: The estimated range is based on boat speed, fuel
consumption, and fuel remaining in the tank. The numbers displayed are
an estimate of the distance you can travel with the remaining fuel. Speed
input required (paddle wheel, pitot pressure, or GPS).
7. Trip: Displays the distance traveled since the gauge was last reset to
zero. Reset: To reset, select the display screen and press "MODE/
SELECT" and "–" simultaneously.
8. Speedometer: Displays the boat speed in miles per hour, kilometers per
hour, or nautical miles per hour. The speedometer will use the paddle
wheel for its low‑speed readings and will switch to the pitot or GPS (if
connected) for high‑speed readings.
9. Fuel Used: Displays the amount of fuel used since the gauge was last
reset to zero. Reset: To reset the fuel used screen, press "MODE/
SELECT" and "–" simultaneously.
10. Course Over Ground: Displays the direction of travel and current speed
through a GPS.
11. To Waypoint: Displays the amount of fuel to the waypoint and the
distance to the waypoint. A GPS unit with waypoints capability must be
installed to display the distance to the waypoint.
eng
SC 1000 SPEEDOMETER
300
MILES
TRIP
25
MILES
MPH
PITOT
FUEL USED
1.5
GAL
COG MPH
TO WAYPOINT
- - -
MI
DIST
52 PORT
30
20
10
0
27
40
50
60
70
80
SPEED
46452