Mercury SC 1000 Operation And Maintenance Manual page 39

When the troll control is engaged and not in the troll control display screen, a
flashing "TR" signal will appear in the upper left corner of the screen to indicate
the troll control is still active.
SETTING TROLL CONTROL
3
2
1
0
b
TROLL SPEED
575
ACT
RPM
PUSH SELECT TO DISENGAGE
TROLL SPEED TOO FAST
4.5
ACT
MPH
REDUCE TROLL SPEED
a - Increase troll set speed
b - Decrease troll set speed
c - Setting is too fast, reduce set troll speed
d - Setting is too slow, increase set troll speed
e - Actual speed
f - Set speed
1. With the engine running, shift the engine into gear. Set the engine speed
at idle.
2. Press in either the "+" or "–" buttons to bring up the troll control display
screen.
3. Press "MODE/SELECT" to engage the troll control.
4. Use the "+" and "–" buttons to set the desired speed. Use "+" to increase
the set speed and use "–" to decrease the set speed.
5. If the troll speed is set to a higher speed than the troll control can
maintain, the "TROLL SPEED TOO FAST" display will appear. Reduce
the set troll speed.
6. If the troll speed is set to a slower speed than the troll control can
maintain, the "TROLL SPEED TOO SLOW" display will appear. Increase
the set troll speed.
eng
TROLL CONTROL
4
5
6
7
RPM
X1000
ON OFF
600
SET
RPM
7.5
SET
MPH
a
b
e
TROLL SPEED
2.5
PUSH SELECT TO DISENGAGE
2.5
c
d
35
40
30
50
20 60
10
0
SPEED
ON
3.0
ACT
MPH
TROLL SPEED TOO SLOW
3.0
ACT
MPH
INCREASE TROLL SPEED
70
80
a
f
OFF
SET
MPH
SET
MPH
46382