Operation And Settings - ElectrIQ Compact V2 User Manual

OPERATION AND SETTINGS

POWER BUTTON
Press to turn unit "ON" or "OFF"
MODE BUTTON
Press this button to select between the Cooling, Fan and Dehumidify(Dry) modes
COOLING MODE: Cold air will be expelled through the front of the unit and hot air will
be expelled through the vent hose.
DEHUMIDIFY MODE (DRY): The dehumidify function can only be used when the room
temperature is above 17̊ C . The unit should be set up without a vent hose, moisture is
extracted from the air that passes through the unit. Continuous drainage should be set
up for the moisture collected (Drainage pipe not included). If continuous drainage is
not set up, the internal water tank will fill and FL will display when full.
FAN MODE: No cooling effect, circulates air within the room, vent pipe not required.
UP & DOWN BUTTONS
o
During the cooling function – These buttons raise or lower the temperature by 1 C for each
o o
press. The minimum temperature is 16 C and maximum is 30 C.
FAN SPEED
Press the SPEED button to select either LOW, MEDIUM or HIGH fan speed.
NOTE: In dehumidifying function, this button is invalid as the unit is designed to run at low
speed in dehumidifying mode.
Page 9 of 16