Selecting System Mode - Carrier ComfortVu TBPL-24-H Installation And Operation Manual

In Two setpoints configuration:
Press the [+] or [-] buttons once - " " and the setpoint
1
temperature for cooling will appear on display.
Use the [+] or [-] buttons to adjust the setpoint for cooling.
2
Press the [Mode] button or wait 3 seconds. " " and the
3
setpoint temperature for heating will appear on display.
Use the [+] or [-] buttons to adjust the setpoint for heating.
4

The setpoint for cooling must be higher than the setpoint for
heating.

For humidity setpoint, see Technician Setting P197.

Selecting system mode

Press the [Mode] button to switch between system modes.
Notes:

During demand for cooling or heating, the active mode will
flash.

In Auto mode, the active mode icon (Cool or Heat) will flash.

Auto mode is not available in 2-Pipe system configuration.
ComfortVu™ BACnet Thermostat Model Standard TB-HM (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide
9
All rights reserved