Miele SmartLine Series Operating And Installation Instructions page 41

Problem
The SmartLine element
has switched off auto-
matically. When the ele-
ment is switched back
on,  appears above the
On/Off sensor con-
trol .
After the SmartLine ele-
ment has been
switched on  appears
in the timer display for a
short while. The Smart-
Line element does not
heat up.
The wok has switched
itself off automatically.
The Booster has deac-
tivated early automatic-
ally.
The cooking zone is not
working in the usual
way on the power set-
ting selected.
An operating noise can
be heard after the
SmartLine element has
been switched off.
Cause and remedy
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
 Clean off any dirt and/or remove the object (see
"Safety features" – "Safety switch-off").
The SmartLine element is in demonstration mode.
 Touch the 0 and 2 sensor controls at the same
time until  flashes alternately with  in the
timer display.
It has been operated for too long.
 Switch the wok back on again (see "Safety fea-
tures" – "Safety switch off").
The overheating protection mechanism has been ac-
tivated.
 See "Safety features" – "Overheating protection".
The overheating protection mechanism has been ac-
tivated.
 See "Safety features".
The overheating protection mechanism has been ac-
tivated.
 See "Safety features".
The cooling fan runs until the SmartLine element has
cooled down and then switches off automatically.
Problem solving guide
41