Wing Servo Installation - Sawn Craft Cherokee 24 Assembly And Setup Manual

Sawn Craft Cherokee 24 Manual

2.7 Wing Servo Installation

•
Parts Required:
o Main Assembly
o 2x Servo Assembly
o 2x Wire Control Rods
1) Using Foam‐Tac, glue the wing servos to the wing between the spar and leading edge ensuring to
align the hole in the EZ Connector with the control horn on the ailerons. Make sure that the servo
is mounted such that the horn rotates as close to perfectly straight in the front/back direction as
possible.
13
2) Once the glue has cured, run the wire from the right aileron servo through the hole in the lower
vertical fuselage.
3) Install the Z‐bend end of each control rod into the hole in the control horn. Gently deflect the
ailerons toward the top of the airframe and insert the straight end of the control rod into the hole
that is in the EZ Connector. Leave the EZ Connector screw loose for now.
BUILDER'S TIP: Bend T‐pins into Z‐bend shape in order to use them to hold components and
other large areas securely.
10/17/16