Sawn Craft Mana‐Tee Manual
2.5 Fuselage Installation
7) Parts Required:
o Main Wing Assembly
o Fuselage Half (2 each)
1)
Apply a bead of glue down the entire length of the flat edge of the fuselage half. Note which side
of the fuselage half has the cut hash marks; this will face inside the completed fuselage.
2)
Press the glued side of the fuselage half onto the main wing assembly, aligning all of the tabs with
the slots in the main wing. Repeat this process for the other fuselage half.
2.6 Servo Installation
8) Parts Required:
o Main Wing Assembly
o Servo (2 each)
1)
Apply a bead of glue on the bottom of the servo mounting tabs. Install the servos into the slots cut
in the main wing, with the servo output spline facing toward the back of the plane.
Page 10
150301 Mana‐Tee Manual.docx