Sawn Craft Micro B‐58 Manual
2.2 Wing Reinforcement Lamination
•
Parts Required:
o Main Wing
o KFm Step
o 4" 0.051" Carbon Rod (2 each)
1)
Lay the main wing on the table with the diagonal carbon rod location markings slot facing up.
Press the carbon rod into the recessed slots to enlarge them slightly if necessary. Apply a bead of
glue around the entire perimeter of the KFm Step.
2)
Press the glued side of the KFm onto the Main Wing with the carbon rods in place, aligning the
leading edges of both parts, and gently slide the parts around to spread the glue evenly.
3)
Set the assembled wing lamination aside to allow the glue to cure. If desired you can place a flat
weight (book, etc.) on top of the lamination while curing to ensure a flat assembly.
4)
Once cured, sand the leading edges to your liking.
Page 5
140927 Micro B‐58 Manual.docx