Sawn Craft Cherokee 24 Assembly And Setup Manual page 19

Sawn Craft Cherokee 24 Manual
BUILDER'S TIP: Make sure the servo cable and the servo extension cable are taped or glued down
so they can withstand some bumping and bruising. This will make your life easier as it prevents
3) Locate the receiver near the nose and fix in place with a spot of glue or Velcro. Make sure you locate
it so the plugs are accessible.
16
4) Solder the ESC and motor wires together and add the correct battery connector to the ESC, ensuring
that the motor spins in the correct direction. Once all of the connections are made, attach the
motor to the firewall such that the wires point down and to the left side of the plane. Run the ESC
radio connector wire to the receiver by passing it through the slot in the lower vertical fuselage.
Tuck the excess wire through the hole provided to make a neat wiring installation. Secure the ESC
with a spot of glue or Velcro.
the connectors from coming apart after an impact.
10/17/16