Table of Contents
Advertisement
Sawn Craft Zero 32 Manual
2.6 Upper Vertical Fuselage Installation
Parts Required:
o Main Assembly
o Upper Vertical Fuselage Assembly
o 3" Carbon Rod
1)
Glue the upper vertical fuselage component in place and hold in position with T-pins until the glue
dries. Apply a bead of glue to the rudder hinge below the elevator. Wipe off excess glue to save
weight.
10
2)
Use some sandpaper and sharpen one end of the 3-inch carbon fiber rod tail skid. Carefully push
the pointed end of the skid into the foam at about the angle shown in the photos. Secure with
foam glue if desired. The preferred location for the tail skid is shown. The skid stiffens the tail
section and saves shock from the rudder servo by keeping the rudder off of the ground.
4/18/16
Advertisement
Table of Contents
